The Armenian project centres on one printed cup format for takeaway beverages. The presentation mentions coffee applications such as latte and mocha. For a packaging producer serving these uses, the artwork, cup geometry and paper specification need to be reviewed together.

Here, the fan is described as 190+15 GSM, and the project sheet identifies PE-coated paper. We keep that notation intact. It describes this order’s material and should not be treated as the entire paper-weight range of the MYC-OCM12.

The customer purchased the basic ultrasonic version of the MYC-OCM12. It is configured to make the selected cup, with a separate table for collecting the finished output. The choice keeps the equipment package focused on cup forming and handling for this particular product.

The machine’s confirmed 1.5–16 oz range includes the selected size. The video gives approximately 80–100 cups per minute as its introduced speed. We recommend assessing production expectations using the agreed paper and cup tooling, rather than converting a reference speed into a guaranteed daily total.

The customer also purchased a cup collecting table. The footage shows finished blue cups arranged at this collection stage, making it possible to review the output and take a sample for measurement.

Our layout guidance is to keep access to the paper feed and collecting area clear. Plan where operators will replenish blanks, remove cups and place inspection samples. These practical steps belong in the equipment discussion even when the project uses a single forming machine.

The presenter checks the sample with a tape measure. The top diameter is described as 7 cm and the bottom diameter as 5 cm, approximately 70 mm and 50 mm respectively. These are measurements of the shown sample, rather than a tolerance specification.

Our recommendation is to compare approved samples against the tooling drawing and examine the side seam, rim and base. If a lid will be used, test it on the actual cup. The video includes no liquid or hot-water test, so beverage holding performance should be checked separately under the intended conditions.